Acetone NFPA 704 Rating and Diamond Explained

Last Updated: 2026-11-04

Answer Capsule: The acetone NFPA 704 rating is 1-3-0: health 1 (blue), flammability 3 (red), instability 0 (yellow), and no special hazard symbol in the white square. Acetone earns the 3 because its flash point is about minus 4 F, so it ignites at room temperature. Post the 1-3-0 diamond at the door of any room or cabinet holding permit quantities.

Your fire marshal stopped at the flammable cabinet and asked why the acetone diamond reads 1-3-0. Most facilities post the diamond because someone told them to, not because anyone read the criteria.

That gap costs you at inspection time. An inspector who sees a placard nobody can explain starts checking the rest of the room. Acetone sits in body shops, labs, nail salons and print shops, so the question comes up a lot.

This post walks through the acetone NFPA diamond number by number: why the red square says 3, why the white square stays empty, and which sign to post where. Brent Hanke at Print Pro AZ has printed hundreds of these for Phoenix shops, and this is the explanation he gives on the phone.

What Is Acetone and Where Is It Stored?

Acetone is a clear, fast-evaporating solvent, CAS 67-64-1, used to thin resins, clean parts and strip finishes. It shows up in almost every kind of facility, which is why the acetone NFPA diamond is one of the first signs a new safety manager orders.

You will usually find acetone in these places:

  • Flammable liquid cabinets in maintenance shops and labs
  • Body shops and fiberglass shops, in 5 gallon cans and 55 gallon drums
  • Print and sign shops, nail salons and cosmetics manufacturing
  • Chemical storage rooms shared with other solvents

Acetone vapor is heavier than air. It spreads along the floor toward pilot lights, space heaters and grinders. That behavior drives the flammability number.

What Is the Acetone NFPA 704 Rating and Why?

Acetone is rated 1-3-0 under NFPA 704 (2022 edition). Each number answers one question a responder asks from outside the door.

Square Rating What the criteria say
Blue (health) 1 Irritation with only minor residual injury
Red (flammability) 3 Flash point below 73 F, boiling point at or above 100 F; ignites at normal temperatures
Yellow (instability) 0 Normally stable, even in a fire; not water reactive
White (special) none Not water reactive, not an oxidizer, not a simple asphyxiant

Health 1. Acetone vapor irritates the eyes, nose and throat. High concentrations can make you dizzy. Those effects clear in fresh air, which is what a 1 means.

Flammability 3. This is the number that matters. Acetone's flash point is about minus 4 F, far below the 73 F line. Its boiling point is about 133 F per the NIOSH Pocket Guide, which is above 100 F, so it lands at 3 rather than 4. A 4 is reserved for materials like propane that boil below 100 F or are already gases.

Instability 0. Acetone does not decompose, polymerize or react with water. It burns, but it does not blow up on its own. A 0 in the yellow square tells the responder the hazard is fire, not detonation.

The NFPA 704 diamond explained pillar covers all four squares with a worked example.

Preview of the NFPA 704 Diamond Field Guide PDF
Free download · 2-page field guide

Print the NFPA 704 Diamond Field Guide

A 2-page field card: how to read every quadrant, the three legal special symbols, sign size by viewing distance, and NFPA 704 ratings for 50 common chemicals with the matching part number. Print it and tape it inside the chemical room door.

The download link appears instantly. No spam, and you can unsubscribe anytime.

NFPA 704 diamond sign printed by Print Pro AZ
NFPA 704 placards · printed in Phoenix

Need placards for a chemical room? Send your inventory, get a quote in one business day.

Attach your chemical inventory or SDS list. Print Pro AZ works out the room rating, prints the NFPA 704 placards on vinyl or aluminum, and ships the same week.

Optional. PDF, Excel, CSV, DWG or images, up to 20 MB. Chemical inventory spreadsheets and SDS binders are perfect.

No commitment. A real person replies within one business day.

Does Acetone Get a Special Hazard Symbol?

No. The white square on an acetone diamond stays blank. NFPA 704 authorizes only three symbols there: W with a line through it for water reactivity, OX for oxidizers and SA for simple asphyxiant gases. Acetone is none of those.

Watch for this: Some older acetone signs carry a flame icon or the word FLAM in the white square. That is not part of NFPA 704. The red 3 already says it burns. Leave the white square empty, or a strict fire marshal can flag the sign.

Do Suppliers Rate Acetone Differently?

Rarely. Acetone is one of the more consistent chemicals in the Print Pro AZ 50-chemical table, and 1-3-0 is the rating on nearly every SDS you will pull. Pure acetone has one well documented flash point.

Blends are different. Acetone-based thinners, nail products and cleaning mixes can carry another health number because of what else is in the can. Check Section 16 of the SDS for the product you actually stock. If Section 16 is silent, take flammability from the flash point in Section 9 and health from Section 11. Never copy a GHS category number into the diamond; GHS runs the opposite direction, with Category 1 the most severe.

Which Acetone NFPA Diamond Sign Should You Post and Where?

Post an acetone 1-3-0 diamond on the flammable cabinet, on any stationary container or tank, and at the entrance to the room where acetone is stored, dispensed or used in permit quantities. IFC Section 5003.5 sets that requirement. The fire marshal can ask for placards below permit quantity if they choose.

Size depends on viewing distance. NFPA 704 Table 9.1 lists a 4 inch diamond for 50 ft and a 15 inch diamond for 300 ft. Verify the edition your AHJ adopted. Here is how Print Pro AZ typically fits the sign to the location:

  • Flammable cabinet door: 3 inch or 9 inch vinyl label
  • Interior storage room door: 9 inch or 11 inch vinyl label, at eye level or above the door
  • Exterior door or outdoor drum area: 15 inch or larger .040 aluminum, since Arizona sun fades vinyl in a season

The acetone NFPA 704 diamond sign, rated 1-3-0 is printed in Phoenix in every size above, as a vinyl label or rust-free aluminum. Mount it clear of the door swing.

One rule that trips people up: the diamond at the door rates the whole room, not just the acetone. If the same cabinet holds xylene at 2-3-0, the door placard becomes 2-3-0, the highest number in each color from any material present. The acetone 1-3-0 sign still belongs on the acetone container itself.

What Other Signs Belong in an Acetone Storage Room?

The NFPA diamond is the first sign an inspector looks for, but not the only one. A typical solvent room in Phoenix gets checked for a full set:

  • NFPA 704 diamond at each entrance and on each stationary container
  • A DANGER: Flammable sign in the OSHA 29 CFR 1910.145 format
  • A No Smoking, No Open Flames sign within sight of the door
  • An SDS location sign and PPE required signage

Print Pro AZ prints the whole set. The free NFPA 704 Diamond Field Guide lists acetone with 49 other common chemicals and part numbers; use the download form on this page to get it.

Here is a call Print Pro AZ gets every month: a shop has an acetone diamond on the cabinet but nothing on the room door, and the fire marshal writes it up. The missing door placard was the problem, not the container label.

Preview of the NFPA 704 Diamond Field Guide PDF
Free download · 2-page field guide

Take the field guide with you

Everything in this article on one printable card: the rating scales, the white square symbols, placement rules, and 50 chemical ratings. Free to share with your crew.

The download link appears instantly. No spam, and you can unsubscribe anytime.

NFPA 704 diamond sign printed by Print Pro AZ
NFPA 704 placards · printed in Phoenix

Ready to placard the building? Get a quote in one business day.

Tell us the rooms, tanks and chemicals. We handle the rest, from the composite rating to an aluminum placard the fire marshal can read from the street.

Start my quote

Or browse NFPA 704 diamond signs and order online.

Frequently Asked Questions

What is the NFPA rating for acetone?

Acetone is rated 1-3-0 under NFPA 704: health 1, flammability 3, instability 0, with no special hazard symbol. The 3 comes from a flash point of about minus 4 F, which means it ignites at room temperature.

Why is acetone a 3 and not a 4 for flammability?

A 4 requires a flash point below 73 F and a boiling point below 100 F, or a flammable gas. Acetone's flash point is well below 73 F, but its boiling point is about 133 F, so it stays at 3.

Does an acetone hazard diamond need an OX or W symbol?

No. Acetone is not an oxidizer and does not react with water, so the white square stays blank.

Do I need an NFPA diamond on a single gallon of acetone?

Usually not. IFC 5003.5 ties the placard to permit quantities, which vary by hazard class and jurisdiction. Your fire marshal can still require one below that threshold.

Conclusion

Acetone rates 1-3-0 under NFPA 704 because it irritates but does not poison, ignites at room temperature, and stays stable in a fire. The white square is blank. Post the diamond on the container and at the room door, and remember the door placard rates every chemical in the room.

Getting the acetone NFPA diamond right the first time saves a re-inspection trip. Have a whole chemical room to placard? Send Print Pro AZ your chemical inventory and we will return the full sign set with the composite room rating worked out, or call Brent at (602) 649-5305.

Sources

Brent Hanke | Print Pro AZ | (602) 649-5305 | b.hanke@printproaz.com

Brent Hanke is the founder of Print Pro AZ, supplying NEC-compliant labels to contractors across the country.


Tags:
NFPA 704 Ratings for 50 Common Chemicals (Printable Chart)

Hydrochloric Acid NFPA 704 Rating and Diamond