Last Updated: 2026-11-13
Answer Capsule: Sodium chloride, sodium bicarbonate and water are each rated 0-0-0 under NFPA 704: no health, flammability or instability hazard and no special symbol. They still get a diamond in a placarded building because a room with no diamond reads as a room nobody rated. Calcium chloride is the borderline case, rated 1-0-0 by some suppliers and 0-0-0 by others.
Your fire marshal just asked for a diamond on the brine room, the baking soda pallet and the DI water tank. You are wondering whether that is a joke. It is not, and the reasoning is simple once you see it from the responder's side of the door.
A firefighter reading placards from outside a burning building cannot tell the difference between "this room has nothing dangerous" and "nobody rated this room." A 0-0-0 diamond removes that doubt. Print Pro AZ prints more 0-0-0 diamonds than most people expect, and Brent Hanke has explained the NaCl NFPA diamond to enough plant managers to know the question is fair.
This post explains why salt, baking soda and water rate 0-0-0, why they still get a sign, where calcium chloride lands, and which sign to post.
What Is the NaCl NFPA Diamond Rating and Why Is It 0-0-0?
Sodium chloride, ordinary salt, is rated 0-0-0 under NFPA 704 (2022 edition) because it meets the lowest criteria in every category. Water and sodium bicarbonate earn the same rating for the same reason.
| Square | Salt, baking soda, water | What the criteria say |
|---|---|---|
| Blue (health) | 0 | No hazard beyond that of ordinary combustible material |
| Red (flammability) | 0 | Will not burn under normal fire conditions |
| Yellow (instability) | 0 | Normally stable, even in a fire; not reactive with water |
| White (special) | none | Not an oxidizer, not water reactive, not a simple asphyxiant |
Health 0. Salt, baking soda and water do not injure a responder on short exposure. Salt dust can irritate the eyes, but not beyond the level of ordinary dust, which is the 0 definition.
Flammability 0. None of the three will burn. Baking soda is used as a fire extinguishing agent, and water puts fires out.
Instability 0. All three are stable in a fire and do not react with water. Salt and baking soda dissolve; water is water.
The NFPA 704 diamond explained pillar covers the criteria for every color if you want the full reading method.
Why Does a Harmless Chemical Still Get an NFPA Diamond?
Because a placarded building rates every room, and a missing diamond reads as a missing rating. NFPA 704 is written for the responder outside the door, not the worker inside. That responder needs to know two things about each room: what is in it, and that someone checked.
Consider a water treatment plant. The chlorine room has a 4-0-0-OX, the caustic room has a 3-0-1, and the salt storage for the brine system has nothing. The responder cannot tell whether the salt room is safe or unrated. A 0-0-0 diamond on that door answers the question before anyone opens it.
The rule in one line: Once your facility placards hazardous rooms, every room with bulk chemicals should carry a diamond, including the ones rated 0-0-0. An empty door is a question. A 0-0-0 is an answer.
Fire marshals in Arizona apply this unevenly. Some require the 0-0-0 anywhere a chemical is stored in bulk. Others only ask for it when the room sits between rated rooms. Confirm locally, and when in doubt, post it. The sign is cheap and the inspection question goes away.
Print the NFPA 704 Diamond Field Guide
A 2-page field card: how to read every quadrant, the three legal special symbols, sign size by viewing distance, and NFPA 704 ratings for 50 common chemicals with the matching part number. Print it and tape it inside the chemical room door.
The download link appears instantly. No spam, and you can unsubscribe anytime.

Need placards for a chemical room? Send your inventory, get a quote in one business day.
Attach your chemical inventory or SDS list. Print Pro AZ works out the room rating, prints the NFPA 704 placards on vinyl or aluminum, and ships the same week.
No commitment. A real person replies within one business day.
Where Are Salt, Baking Soda and Water Stored in Bulk?
These three show up in bulk in more facilities than most people realize:
- Water softener salt and brine tanks at treatment plants, hotels and car washes
- Sodium bicarbonate for pool alkalinity, flue gas treatment and food processing
- Deionized and reverse osmosis water tanks at labs, dialysis centers and electronics plants
- Ice melt and dust control stock at facility yards
- Food and beverage ingredient storage
The pool room is the classic case. It holds calcium hypochlorite at 3-0-2-OX, muriatic acid at 3-0-0, and a pallet of baking soda. The door placard shows 3-0-2-OX, the highest number in each color from every material present. The baking soda pallet still gets its own 0-0-0 label so the crew knows that pallet was rated.
Is Calcium Chloride an NFPA 0-0-0 or 1-0-0?
Both ratings appear on supplier SDS sheets, and the Print Pro AZ 50-chemical table marks calcium chloride as one where suppliers commonly differ. Some rate it 1-0-0 for eye and skin irritation and the heat it releases when it dissolves. Others rate it 0-0-0. Neither is wrong under the criteria.
Calcium chloride is used for ice melt, dust control, pool hardness, concrete accelerators and brine. It gets warm when dissolved, but not enough to earn an instability number or a W symbol. The blue square is where the disagreement lives.
Use the rating in Section 16 of the SDS for the product you stock. If Section 16 is silent, take health from Section 11. Do not copy a GHS category into the diamond; GHS Category 1 is the most severe and NFPA 1 is the least, so a direct copy is backwards. Print Pro AZ does not present a single rating for calcium chloride, and neither should your sign vendor.
Which 0-0-0 Sign Should You Post and Where?
Post the 0-0-0 diamond at the door of the storage room and on stationary tanks such as brine tanks and DI water tanks. IFC Section 5003.5 ties placards to permit quantities, and these materials rarely reach one. The 0-0-0 goes up because the fire marshal asks for it or because your facility rates every room, not because a code section demands it.
Size follows NFPA 704 Table 9.1, from a 4 inch diamond at 50 ft to a 15 inch diamond at 300 ft. Verify the edition your AHJ adopted. For 0-0-0 locations, Print Pro AZ typically recommends:
- Pallets, bags and totes indoors: 3 inch vinyl label
- Storage room door: 9 inch vinyl, at eye level or above the door
- Outdoor brine or water tank: 15 inch .040 aluminum, since Arizona sun fades vinyl
The 0-0-0 NFPA 704 diamond sign for non-hazardous materials is printed in Phoenix in every size above. The full table of ratings for salt, baking soda, water, calcium chloride and 46 other chemicals lives in the NFPA 704 ratings for 50 common chemicals chart.
Here is a call Print Pro AZ gets every month: a hotel engineer orders 0-0-0 diamonds for the softener salt room after the fire marshal walked past it and asked "what is in there?" The sign answers that question before it gets asked again.
Take the field guide with you
Everything in this article on one printable card: the rating scales, the white square symbols, placement rules, and 50 chemical ratings. Free to share with your crew.
The download link appears instantly. No spam, and you can unsubscribe anytime.

Ready to placard the building? Get a quote in one business day.
Tell us the rooms, tanks and chemicals. We handle the rest, from the composite rating to an aluminum placard the fire marshal can read from the street.
Start my quoteOr browse NFPA 704 diamond signs and order online.
Frequently Asked Questions
What is the water NFPA diamond rating?
Water is rated 0-0-0 under NFPA 704: no health, flammability or instability hazard and no special symbol. It still gets a diamond on bulk tanks in a placarded building so responders know the tank was rated.
What is the sodium bicarbonate NFPA diamond?
Sodium bicarbonate, baking soda, is rated 0-0-0. It does not burn, does not react with water and does not injure a responder on short exposure.
What is the calcium chloride NFPA diamond?
Suppliers differ. Some rate calcium chloride 1-0-0 for irritation, and others rate it 0-0-0. Use the rating in Section 16 of the SDS for the exact product you stock.
Do I have to post a 0-0-0 diamond?
No code section requires it below permit quantities. Fire marshals ask for it because a room without a diamond in a placarded building looks unrated. Most facilities post it to close the question.
Conclusion
Salt, baking soda and water rate 0-0-0 under NFPA 704 because they meet the lowest criteria in every square. They still get a diamond because a placarded building rates every room, and a door with no diamond looks unrated to a responder. Calcium chloride is the borderline case at 0-0-0 or 1-0-0, and the SDS for your product decides.
A 0-0-0 sign on the brine room is the cheapest inspection question you will ever close. Rating a whole facility? Send Print Pro AZ your chemical inventory and we will return the full placard set, including the 0-0-0 rooms, with the composite rating worked out. The free NFPA 704 Diamond Field Guide has all 50 chemicals; use the download form on this page to get it, or call Brent at (602) 649-5305.
Sources
- NFPA 704, Standard System for the Identification of the Hazards of Materials for Emergency Response
- International Fire Code 2021
Brent Hanke | Print Pro AZ | (602) 649-5305 | b.hanke@printproaz.com
Brent Hanke is the founder of Print Pro AZ, supplying NEC-compliant labels to contractors across the country.