Last Updated: 2026-11-06
Answer Capsule: The sulfuric acid NFPA 704 rating for concentrated acid is 3-0-2-W: health 3 (blue), flammability 0 (red), instability 2 (yellow), and the W with a line through it in the white square for water reactivity. Dilute solutions such as battery acid rate lower, so use the SDS for the exact product and concentration before ordering the sign.
Your forklift battery room has a jug of electrolyte, and your treatment shed has a tote of concentrated acid. Someone ordered the same sulfuric acid NFPA diamond for both doors. One is wrong.
Sulfuric acid is the chemical where concentration changes the placard most. Concentrated acid earns a water-reactive symbol and a 2 for instability. Diluted, it loses both. Print Pro AZ fields this question weekly, and Brent Hanke has seen 3-0-2-W posted on rooms that should carry something lower.
This post explains each number on the concentrated sulfuric acid diamond, what the W symbol tells a firefighter, why dilute acid rates lower, and which sign goes where.
What Is Sulfuric Acid and Where Is It Stored?
Sulfuric acid, CAS 7664-93-9, is a dense, oily, corrosive liquid. Diluted with water it becomes the electrolyte in lead-acid batteries. That is why "battery acid" is a common search for the sulfuric acid NFPA diamond.
You will find it stored in these places:
- Forklift and standby battery charging rooms, as electrolyte
- Water and wastewater treatment plants, for pH control
- Metal finishing, plating and pickling operations
- Chemical manufacturing and labs
The oldest handling rule still holds: always add acid to water, never water to acid. Concentrated sulfuric acid releases a burst of heat when water hits it, enough to boil and spatter. That reaction drives the W symbol and the instability rating.
What Is the Sulfuric Acid NFPA 704 Rating and Why?
Concentrated sulfuric acid is rated 3-0-2-W under NFPA 704 (2022 edition). Here is the reasoning square by square.
| Square | Rating | What the criteria say |
|---|---|---|
| Blue (health) | 3 | Short exposure could cause serious temporary or moderate residual injury |
| Red (flammability) | 0 | Will not burn under normal fire conditions |
| Yellow (instability) | 2 | Violent chemical change at elevated temperature and pressure, or reacts violently with water |
| White (special) | W with a line through it | Reacts dangerously or unusually with water |
Health 3. Concentrated sulfuric acid causes deep chemical burns on contact and severe eye and airway damage. A short exposure can cause serious injury, the definition of a 3.
Flammability 0. Sulfuric acid does not burn. It can react with metals to release hydrogen gas, which does burn, but that is a storage issue. The red square stays 0.
Instability 2. The 2 comes from the water reaction. NFPA 704 rates a material that reacts violently with water as a 2 in the yellow square.
The NFPA 704 diamond explained pillar covers all four colors with a worked example.
Print the NFPA 704 Diamond Field Guide
A 2-page field card: how to read every quadrant, the three legal special symbols, sign size by viewing distance, and NFPA 704 ratings for 50 common chemicals with the matching part number. Print it and tape it inside the chemical room door.
The download link appears instantly. No spam, and you can unsubscribe anytime.

Need placards for a chemical room? Send your inventory, get a quote in one business day.
Attach your chemical inventory or SDS list. Print Pro AZ works out the room rating, prints the NFPA 704 placards on vinyl or aluminum, and ships the same week.
No commitment. A real person replies within one business day.
What Does the W Symbol Mean on a Sulfuric Acid Diamond?
The W with a horizontal line through it means the material reacts dangerously or unusually with water. It is one of only three symbols NFPA 704 allows in the white square, with OX and SA.
For a firefighter, the W changes the plan. A hose stream into a spill of concentrated acid can spatter and surge with heat. Responders reading the W from the door know to protect the crew from the reaction, not just the fire.
Check the artwork: The line through the W is part of the symbol. A plain W is not an NFPA 704 symbol and can be flagged by a strict AHJ. Print Pro AZ prints the struck-through W on every sulfuric acid diamond.
The NFPA 704 special hazard symbols post covers what a responder does differently for each symbol, and why letters like COR do not belong inside the diamond.
Why Do Dilute Sulfuric Acid and Battery Acid Rate Lower?
Dilute sulfuric acid rates lower because the water reaction is already done. Battery electrolyte was mixed with water at the factory. Adding more water does not produce the violent heat surge, so the W symbol and the instability 2 no longer apply. The health number often drops as well.
Print Pro AZ does not publish one rating for dilute or battery-grade acid, because suppliers differ and the number depends on concentration. Use the SDS for the exact product on your shelf. Section 16 often lists the NFPA rating; if not, take health from Section 11, instability from Section 10 and water reactivity from Sections 5 and 9.
Do not copy a GHS category number into the diamond; GHS Category 1 is the most severe and NFPA 1 is the least, so a direct copy is backwards. And if a battery room also holds concentrated acid for topping up, the door placard carries the concentrated rating.
Which Sulfuric Acid NFPA Diamond Sign Should You Post and Where?
Post the 3-0-2-W diamond on every stationary tank or container of concentrated acid and at each entrance to the room where it is stored or used in permit quantities. That is IFC Section 5003.5. Your fire marshal can require it at smaller quantities, and many do for acid.
Size comes from NFPA 704 Table 9.1: 4 inch for 50 ft of viewing distance up to 15 inch for 300 ft. Verify the edition your AHJ adopted. For sulfuric acid, Print Pro AZ typically fits:
- Totes and drums indoors: 3 inch or 9 inch vinyl label
- Battery room or chemical room door: 9 inch or 11 inch vinyl, at eye level or above the door
- Exterior tank or outdoor treatment shed: 15 inch or larger .040 aluminum
Acid vapor and Arizona sun both destroy cheap signs, so go aluminum outdoors. The sulfuric acid NFPA 704 diamond sign rated 3-0-2-W is printed in Phoenix on rust-free .040 aluminum or vinyl in every size above.
The room rule still applies. The door placard shows the highest number in each color from every chemical inside, plus every symbol present. A treatment room with sulfuric acid at 3-0-2-W and sodium hydroxide at 3-0-1 gets a 3-0-2-W door placard.
What Other Signs Pair With a Sulfuric Acid Storage Area?
A sulfuric acid room or battery charging area is usually checked for this set:
- A DANGER: Corrosive sign in the OSHA 29 CFR 1910.145 format
- An eyewash and shower sign, required by OSHA 1910.151(c) wherever corrosives are used
- PPE required signage for gloves, goggles and face shield
- A No Smoking sign in battery rooms, where charging releases hydrogen
- An SDS location sign
Here is a call Print Pro AZ gets every month: a warehouse posts 3-0-2-W on the forklift charging room, and the fire marshal asks for the SDS. The electrolyte SDS shows a lower rating, and the sign gets replaced. Matching the sign to the SDS the first time avoids that trip.
The free NFPA 704 Diamond Field Guide lists sulfuric acid with 49 other common chemicals and part numbers; use the download form on this page to get it.
Take the field guide with you
Everything in this article on one printable card: the rating scales, the white square symbols, placement rules, and 50 chemical ratings. Free to share with your crew.
The download link appears instantly. No spam, and you can unsubscribe anytime.

Ready to placard the building? Get a quote in one business day.
Tell us the rooms, tanks and chemicals. We handle the rest, from the composite rating to an aluminum placard the fire marshal can read from the street.
Start my quoteOr browse NFPA 704 diamond signs and order online.
Frequently Asked Questions
What is the NFPA rating for sulfuric acid?
Concentrated sulfuric acid is rated 3-0-2-W under NFPA 704: health 3, flammability 0, instability 2, with the water-reactive W symbol. Dilute solutions rate lower, and the SDS for the exact concentration governs.
What is the battery acid NFPA diamond?
Battery acid is dilute sulfuric acid, so it usually rates lower than 3-0-2-W and often without the W symbol. Suppliers differ, so use the rating in Section 16 of the SDS for your specific electrolyte rather than a generic number.
Why does sulfuric acid have a W symbol?
Concentrated sulfuric acid reacts with water by releasing heat fast enough to boil and spatter. NFPA 704 marks that with the W with a line through it so responders avoid putting a hose stream into the material.
Is sulfuric acid flammable?
No. The red square is 0. The hazard is corrosive contact and the violent reaction with water, not fire.
Conclusion
Concentrated sulfuric acid rates 3-0-2-W under NFPA 704: a serious contact hazard, no fire hazard, a 2 for the violent water reaction, and the struck-through W to warn responders. Dilute acid and battery electrolyte rate lower, and only the SDS for your product says how much lower. Post the sign on the container and at the door, and let the door placard carry the highest rating in the room.
Getting the concentration right on the sulfuric acid NFPA diamond keeps you from replacing the sign after inspection. Placarding a treatment plant or battery room? Send Print Pro AZ your chemical inventory and we will return the full placard set with the composite room rating worked out, or call Brent at (602) 649-5305.
Sources
- NFPA 704, Standard System for the Identification of the Hazards of Materials for Emergency Response
- OSHA 29 CFR 1910.151, Medical Services and First Aid
Brent Hanke | Print Pro AZ | (602) 649-5305 | b.hanke@printproaz.com
Brent Hanke is the founder of Print Pro AZ, supplying NEC-compliant labels to contractors across the country.